tintop
Senior Member
Posts: 232
|
Post by tintop on Feb 25, 2011 0:54:25 GMT 1
Hi guys
How do i adjust the camber on my front wheels?
The bottom is tucked in on near side.
|
|
|
Post by Twodogs on Feb 27, 2011 14:40:23 GMT 1
Can't help you with that one Martin, have you had a look in Hanyes manual? I'llhave a look in the Bennetts service book.
Cheers Mick
|
|
tintop
Senior Member
Posts: 232
|
Post by tintop on Mar 2, 2011 23:29:02 GMT 1
I will dig the book out, i have put it somewhere safe!
Just can't remember where.
|
|
|
Post by mavisdub on May 24, 2011 11:21:23 GMT 1
One of the ball joints has a cam shaped sleeve on it which you turn to adjust the camber. This sleeve will more than likely be seized on so you will have to split off the joint to get to it. You can't just spin the ball joint round as they move in a slot whereas most car ball joints you can. have a look at the ball joint and you will see the cam as it has flats on for a spanner. Hope this helps. Regards, Chris
|
|
|
Post by gvee on May 27, 2011 1:01:46 GMT 1
Martin, give us a nod if you still need this looking at - I did mine when I fitted my new spindles. It's just a nut on one of the ball joints and I have the correct spanner size (i.e. girt big!) for the job too. P.S. also have access to a ball joint splitter (just need to pick it up) which should make the job a breeze should the joint need to be popped out of the spindle
|
|